MR-1 build with mods

[Kawika]

Extending the base plate and adding additional anchor points

Of course, with an extended baseplate, machining the surface is a challenge since it cannot be reached. I rotated the X axis 180 degree to reach the rear once the front was roughed out. Here is the reach when the spindle is at the front of the X carriage, roughing pass done. The plate was quite flat, I did not have to take much off to get to this. [Front Done] Now undo the X axis bolts and rotate the spindle 180 degrees. I had some car dollies in the shop so used that to easily rotate it cl…