I am uploading a video of your test cut as we speak, just check back for the edit of this post to watch it.
Here’s the resulting piece of that video though -
The tiniest bit of beveling, but will only get worse because your file still resulted in a .02" cut height which tells me it’s not a CAD/CAM issue on my end -
I did run multiple pieces however, and when running smart voltage, I had the same 93.7v I described earlier.
HOWEVER in the video above, I manually entered 120 and this time I had a slightly higher average voltage.
Oh and no one asked but I’m providing this information - yes the laptop being unplugged (on a separate outlet anyway) does not change voltage as I read that a ground issue can result in a lower voltage with a laptop plugged in.