Here is a project I have been working at the last week and a half or so. This was all cut on my Pro table. See my indexing linked here on the forum if you haven’t watched it. Anyway, it is finally fully braced and these are pics getting ready to do the final weld. This is an 8 foot weld running the entire vertical distance of the sign. right down the center. This is 16 gauge material. For those that haven’t done a task like this. Its super easy to put too much heat in the material and screw up the entire project!! It is done, and I will share some pics of the final results later. I haven’t taken any yet. This is almost 8ft by 8ft. What do you think? All of the cutouts will be filled with sheets of acrylic and backlit for a local wind generation company near here.
13 Likes