Hi guys! I’m sorry if I’m violating the forum rules, but I was hoping I might get some timely feedback to help me through this project. This is my 3rd cut, and I was looking for some advice on reducing the pierce marks and waviness in some of the lettering. I am using the Crossfire Pro w/THC, Razor Cut 45, my air is coming from a 7.5hp 80gal IR compressor with RTI filters, mini desiccant dryer and a motor guard just ahead of the cutter. This steel is 1/8". My goal is to make a 3’ one that would look similar for a new restaurant that’s in construction, so any advice on how to clean this up would be really really really appreciated over here.
A post was merged into an existing topic: Feedback/Help Getting Started (wiggle)