Sheet Metal Pricing

1

Good morning everyone! I’m finally getting comfortable cutting stuff on my table and running out of scrap to learn on, I started researching local material around so I can dive into projects. What kind of pricing do you guys see? The image below is pricing for today at a place near me. (I’m in New Hampshire) Any input / feedback between Cold Roll, Hot Roll, Hot Roll P&O ?

thanks !

mtl
mtl614×461 37.7 KB

2

Those prices don’t look too bad … I try to buy 14ga and .250 in bulk to get better pricing.

I normally buy hot rolled and prep it myself.
P&o is easier I am just afraid it may rust before I use it …

1 Like
3

Those prices are not bad compared to what I have priced last but I think I bought during a peak a few years ago. It is moving higher though.

image
image1077×920 150 KB

If you look at a few topics on the forum in past years, it fluctuates a lot both in years and areas of the country.

1 Like