started working on the water pump system this weekend.
cut out 4 connection plates on the new table to make the lower shelf removable, and i didnt want to weld to the table also.
Used 1/4-20 Riv Nuts, set into the frame legs. rack bolts right up.
frame legs with Riv Nuts
also got rid of the brass drain fittings since they never fully drain and they are too small. I got a 1"NPT nipple, 3" long and cut it in half to make two drain ports.
tried welding them on, but TIG welding is way too bright for my welding hoods that have been sitting in my garage for too long without being used and now they are wont darken. MIG welding the frame, no problem, little squint, not too bright.
will have them welded up tomorrow after i bring my hood home from work.
