Index Cut with the CrissFire Pro and Fusion 360

[Greg9504]

You might want to add a fence to the table for squaring. It will make squaring your stock faster, just slide the sheet up. I’ve been doing something similar to your 3D printed pointer with an Easyscriber. Anyway nice video.

Fence info:

Indexing Jig ideas

Yes. Here’s my first crack at it: [image] I found I needed to use an additional removable spacer between the fence and the sheet. Otherwise the fence would be in the way of the torch. Not ideal. The fence stays in place, when you want to load a sheet, put the spacer on (it’s 1/2" stock), put sheet on. Remove spacer, cut. Put spacer back on, slide sheet to make indexed cut, remove spacer, repeat. I’m open to better ideas. I (think have to double check) the length is 51-1/2", holes wer…