Inconsistent cut on 3/8" steel

[TinWhisperer]

@yekcoh

That’s possible. How can I check that?

HF titanium 45 with x45 machine torch problems

[20250317_173943] [20250317_173950] Once again you’ve helped me figure it out! Turns out there’s an internal regulator that wasn’t set high enough for the torch I had installed. Turned the regulator up a couple turns and she’s working. So now I’m going to put it back to how it was to figure out how many PSI the factory settings are so when I use the handheld torch I’m not using too much air and then I’m going to add another regulator for my machine torch. Thank you guys again for helping …