HYP Fine Cut Consumables HELP

[ChelanJim]

@Bastrawn

Now i just need to figure out how to resolve the cut height

This should help you understand partly what is going on…(except when THC gets involved and complicates this straight forward check).

Ideas on fixing an interior letter that fell out

If you run this gcode with FireControl: cut height test.tap (224 Bytes) This will run the table/torch as if it is going to start a cut. It will go thru the IHS to determine the surface of the metal and will allow the assumption of the springback to be set at 0.020 inches. It will then set the torch at what it expects to be 0.060 inches and without firing the torch, STOP. You can now measure with the feeler gauge to see what your cut height, in reality is really being set at when you thought …