How to cut a single line

[TinWhisperer]

Tool path generation fail

[ls contour 2] I couldnt get that DXF file in load I altered the format and can tell there is a few layer in here. [ls contour 1] here is a piece of that corrupted file. something missing in translation. Does that DXF load on your fusion360? you could export a *.F3D, zip and share that with us. From this menu you also can export all the layer into one DXF ( this also could create a cornuted file depending on how the layers interplay) [ls contour 3] [ls contour 4] Here you can export…

This post goes through how to export a f3d file from Fusion 360.

This is a video that also explains the exporting of an f 3D file.

Practical Fusion 360 Videos

Video 3 The points in this video we will visit are: Creating , Inserting, Exporting Files to and from Fusion 360 Create a DXF using “project” command Posting file for collaboration File types: F3D ,DXF ,SVG ,PNG Here is the Video https://www.loom.com/share/3c47332e858e454fa334c9f6e529fc3c Attached is all the project files from Video 3 [Sample Plate Video 3 v1 2] [Sample Plate video 3|80] [Sample Plate Video 3 v1 1] Sample Plate video 3 test.dxf (3.1 KB) Sample Plate V…

@thebigorangescout

Also which of these settings is causing the hole at the end of my lines?

I’m not sure you’re F3D file will tell me more.
What kind of plasma torch setup are you using?

I asked cuz some torches just aren’t quite as quick with the “torch off” signal.