HELP! x axis not tracking correctly

[Phillipw]

You may want to check the voltage coming to the motors. I will try to find you a link.
https://forum.langmuirsystems.com/uploads/db6772/original/3X/2/3/23454c428df25db5015eb548665558003ed60f3f.jpeg

Try looking here

X Y axis stops abruptly

Has anyone experienced issues with the servo motors stopping abruptly during a cut, but the program continues on like the torch is still moving? Fortunately I experienced this in dry-run mode and didn’t waste material. I started to exercise the table in both directions and found when the x-axis does this, I can gently grip the motor coupling and turn it and it will start again, but it repeatedly does it. This table is 3 years old and never had an issue before, but it probably doesn’t have 30 m…