Cut out some of the future washers haha. I didnt notice any difference in dross and paused during the cut height was definitely close to .1". Amperage had no effect on dross, nor did playing with THC settings.
From there I increased the amperage to 45 and the speed up to the 170 IPM and had almost no dross except were the lead in was really.
I performed the line cut from last night at 45 amps and had the program sped up to a max of 200 IPM, (160%. Increase). The last few lines had almost no dross except near the start and finish.
Are those settings I should live with?
I tried lower amperage and lower speed, like 25 amps and 70 ipm and still had dross.