Can I just pierce a hole? Using fusion 360 for design and post

[TinWhisperer]

@ChelanJim

P.S. I am back to liking Fusion 360 again.

Excellent, That is what I like to hear!

I am looking forward to your pictures of your work.

I did just post a new video on single line cutting too, please check it out when you have time.

Practical Fusion 360 Videos

[push pull iso sim] [PUSH PULL TinWhisperer v1] **Video 6 ** The points we visit in this video are: Creating x2 single line lettered plates in Fusion 360 Here is the Video **Video 6 ** https://www.loom.com/share/db876f6c81a944ca9d135b4756312964 Project files PUSH PULL TinWhisperer start v1.f3d (43.0 KB) PUSH PULL TinWhisperer finished v1.f3d (125.3 KB) PUSH PULL.nc (5.5 KB)