Here are my post process settings; mind you I’ve never changed anything before or after with the exception of pierce delays.
And correction, I guess I never had that box checked. It asks for some machine library so it’s unchecked and I guess it always has been unchecked.
Here I ran .06 cut height on purpose -
The actual cut height -
The results of cutting -
Then I ran it at .1 cut height -
And same results -
I can literally stack both parts and they’re the same -
Going from .06" to .1" cut height made no physical changes as they both netted to .02".
Anything wrong in my post process? Odd because again, I change nothing at all other than pierce delays this entire year I’ve run my table.