Y axis binding both rails

[TinWhisperer]

@caddy make sure the red brackets are in the right locations (links below)

What to do about jogging before tighting screws

All good. So I would make sure that you have the right red brackets installed on the y-axis. [Screenshot_20220423-085306] I would also snug these up but not tighten them up more so than they currently are. [Screenshot_20220423-093735] I would also take some kitty corner or crossways measurements on your machine just to make sure that it isn’t racked. When in any doubt there is no problem in going back some steps and just double checking.

What to do about jogging before tighting screws

It’s not my image, but here it is [CDBB394C-A182-4000-9659-69312B87147D]