Tracing a canvas using spline tool or other method?

[PC-PlasmaCut]

I realize it’s easier and faster to trace something vs using an SVG converter. Even using Ilustrator doesn’t do a great job. The main problem being double triple lines everywhere and makes the software wig out.

Any other methods? I do have a Wacom tablet, maybe using a pen while tracing?

If you can’t use an Arch tool for a nice curved line, seems you have to use the spline tool, even then it takes a lot of time adjusting the points to get the line even. Overall I don’t think is super critical as the cuts appear to be fine, but in some smaller projects you can see the line as a slight wiggle to it.

[TinWhisperer]

@PC-PlasmaCut

but in some smaller projects you can see the line as a slight wiggle to it.

This is where 2d profile menu tolerance and smoothing can help. move the decimal down one.

@PC-PlasmaCut

Any other methods?

depending on the workflow ? this tool could be handy

Sketch to SVG. Shaper TRACE

This device is so you can draw and change that directly into a SVG! Sounds amazing and super useful for us. KickStarter is up on June 22nd so you should be able to snag a discount there [Trace_Logo] [3dbc75a0-d4d8-4fc8-9646-350c22316987_KSA_Trace_Studio-629-Edit] [Screenshot_20230616-182840]