Titanium Plasma 65 CPC port

[JTLAMPE77]

I should have noticed this one earlier:

50 to 1 voltage divider

The voltage input module supplied by langmuir. Well process your raw voltage so that your torch height controller chip can recognize it without being fried. The voltage input module takes the raw voltage and uses resistors to divide it to a low enough voltage to be safe for the electronics. The electronics at this point multiplies that reduced voltage to get the actual voltage to base its decisions off of. The voltage input module is essentially a 50 to 1 voltage divider or equivalent inside…

If there’s no risk of melting the CPC port with an arc fault between the RV taps then plans A and B are both trivial.

I’m waiting on parts and enough free time to execute Plan C. I will send word once I have progress to report.