I just got my Crossfire Pro in Sept,Just getting it going now. Right away,I found the Instructions for the table,showed the Control connections on the Razorweld with 50:1 on Left,and a piece of paper in with the machine showed it on the Right,Contacted Langmuir Support,they said connect as the tag in the cutter-pkg showed,not as the table-instructions showed,is this correct? I also have No Torch Firing,or THC. Checked the Relay,its tight,as is the board connection. On the THC-Board,the Green and Red lites are on,there is another Yellow light flickering,is this normal,or an indicator of an issue? We just updated FireControl last night as well. Everything else is up to date,as far as I know. Im going to run more diag on it tomr.Just trying to make sure these few things arent an issue.Thanks,Mike.