Re-pin a PTM 60 torch - Solved

Plasma Cutters
1

I’ve seen a couple posts talking about making the PTM 60 torch work for their cutters. We got one for our Everlast PP 60s. I figure we just have to move the pins from 1 and 9 to somewhere else on the connector but what is everyone using for swapping the pins around?

It looks like in our case pin 1 and 9 are for the trigger on the torch that came with the welder and arent needed with the PTM 60.

2

@truehybridx welcome to The forum

@mechanic416 goes into it and some detail in this form topic.

1 Like
3

Thanks for the info. I got it done.
Just needed to be brave enough to tug on the pins since these were two piece.

2 Likes