Ok I have run my first test with the torch and I like it quite a bit. I have some finessing to do in regards to feeds and speeds. My dross was heavy due to going too slow. The torch came with 45 amp tips. I was running at 30A at around 103 ipm. Way to slow for how this torch was cutting 14ga mild steel. Might have to talk to George @mechanic416 about that a little bit. Overall quality is good though. My kerf was reasonable and not overly noticeable based on my eye ball of .035 away from the plate and the slow speed. The quality and overall build of the torch is top notch. Swapped it for my old torch in a matter of minutes. Detail on the work piece was good for the size of a 45Amp nozzle orifice and the 9 inch size of my artwork. Best part is its shielded, fully adjustable for the amperage of the razorweld45 and the consumables are easy to remove. Looking forward to installing this on my pro. Also, these are Steve Abner’s custom made machine torch holders @Lil_Abners_Kustoms
