Had very little time to mess around today. I cut a few more pieces out with great beginner results. I had a pretty major tip up on one cut. The piece was awkwardly shaped and I just couldn’t get it with the magnet. I went to pause the program but it was too late. The Z axis went down for IHS and the shield hit the top of the tip up. So the Torch was about 1" over the sheet when it fired again. Firecontrol paused the program and popped up a caution. I pulled the piece out. Firecontrol recommended I start the program from the last loop. I did and it picked right up from the last cut. I was blown away. This is my first plasma but this just seems like a huge time saver. My 8 year old son was watching and he was even impressed.
5 Likes