Well im sure most of you have gotten this but i finally got opp 1 and opp 2 to run in the same nc file with the same tool used. G54 and G55
3 Likes
Nice!
I haven’t run into a situation where I’ve needed to run two work offsets at the same time, but good to know its working. Has it been an issue?
No, no issue. Im new to all this and needed to be able to run more than one offset for left and right parts.
1 Like
Oh, alright then.
Glad to know it works properly👍
Could definitrly be handy when making a run of parts. I still get 1 off parts for friends and such, but once I get everything rolling I may toss a job or two at it that requires this. Thanks!