Сontour and circle cutting quality

[TinWhisperer]

Can you export and post your *.f3d file?

@Hennadii

but the outer circuit disappears when the plasma exits and does not operate the output circuit, that is, the protrusion of the outer circuit remains

You think you could screenshot this I’m not sure what you mean by your description?

This link has a test file in it which is the same circle square file you have could you give it a try?

Another THC misfire (Re titled )

test square.nc (991 Bytes) [test square v1] try this simple test square 2"x2" 1" hole at 100ipm .06 cut height .15 pierce height .6sec pierce delay use smart voltage by setting the thc voltage to 0 volts I am still suspect of the dry contact vs xfer connects ( jumper ) in the machine. These need to be in the dry contact position. Page 53 of the manual can you take a picture of this location. Clamp on material for sure!