No way to connect support real time [Solved]

[TinWhisperer]

Y Axis stops and won't more

I have an issue where the Y axis stops moving about 2/3rd from the home switch, sometimes I can get it to jog back, others I have to push it. Usually stops pretty far from the motor, Do I need a new stepper motor for this? Had it just under a year but I have been using it a lot. it is almost like it does not have enough power to push it all the way.

Is it the Y stepper motor from your issue last week.

I believe they are a NEMA 23 motor?

@Gogo

Bad timing for Langmuir as I am getting ready to upgrade to a larger table and this is a big strike against them

The XR comes with a phone in tech support line, The PRO and OG does not . This is by design and is built right into the pricing structure of these units so they can be cost effective.