Miller 625 Extreme not re-firing after move

[James5]

Yep - same setup here. If you are using Fusion360 - I found setting the pierce delay to about 1.2 seconds worked for me. You may have to play with this some to find right value.

Adventures in metal cutting

I’ve learned a few things so far: The pierce delay needs to be about 1-1.2 seconds in fusion 360. I kept getting issues where the torch would start moving without the pierce - especially when the feed rate was up - I think the torch needed a second or two to restart after the initial start. I’ve read about this in the forum, but still not exactly sure whats going on there. I suspect the “arc ok” or “ok to move” signal from my plasma is what is supposed to address that - but there’s no hook…

See comment from Langmuir-Daniel in this thread.