Machine doesn't follow toolpath

[DWalls]

@TomWS

A brief write up should be fine

Here is a link to the new thread that I started to explain how I use the M06

M06 for beginners

I will try to do this from memory so you can try it and I will double check it tomorrow since I don’t have my computer with me today. First you go to the config tab in Mach3 and the General settings, on the left side you will see a box for M06, there you will choose the option that says wait for cycle start, not sure of the wording. Second, you load your gcode file into Mach3 and choose Edit Gcode. It should open up with notepad. Once open then you choose Edit then Replace and on the top line …