It's been awhile. Post those projects!

[ChelanJim]

I did a little reading and found this post that allows Fusion to automatically add in an allowance with your cuts. I have not tried it.

Cutting Slots Oversize or Not?

@TinWhisperer I may have found a way to cut the slots oversize in Fusion. In the 2D profile in the Passes section, there is a “Stock to Leave” option. It is to leave material that you will later want to clean up on the mill. It says you can put in a negative number to “remove more stock than the model shows”. This should cut oversize instead of leaving extra material to be milled. Should have known. This is a standard feature on most CAM programs. [image]

Edit: The more I think about this, the more I can’t see how this would work since it would change the dimensions of your entire piece rendering the “creating allowances” moot. Perhaps I am looking at it wrong.