I have a Hypertherm 45XP without cpc port. I currently have it wired for my torch control for my OG XL Crossfire. When I bought my new Crossfire Pro Table I ordered the THC and the cables for connecting to the table. Cable listed below:
My Question is does anyone know the cpc port I need to order that I wire into my Plasma Cutter?
Thanks in advance for any help.
Since your machine does not have a cpc port factory installed you have two options.
- Install a cpc port on for 45XP and use the cables you bought to hook to the LS-THC
this thread has some details and links
langmuir forum hypertherm-45xp-upgrade-question
Service Manual Page 108 - 110
- Install Raw voltage pigtails and use that method to the LS-THC and do not use the cables you bought.
scroll down to 4: PLASMA CUTTER WITHOUT CNC PORT (RAW VOLTAGE)
1 Like
Thank you. I want to install the cpc port, but I can’t find the part number.
Hypertherm Upgrade Kit - CPC Port w/ Selectable Voltage Ratio - 428653
Hypertherm Upgrade Kit - CPC Port w/ Selectable Voltage Ratio - 428653
I believe this is what you are looking for but please double check with the seller.
Search “kit 428653” in google and there are quite a few vendors
1 Like
This is your support page for the Hypertherm 45XP
45XP Support Page
there is an exhausting amount of material about your machine.
Here is a link to the install manual for kit 428653
CPC 428653 install manual
1 Like
If you do end up choosing to go to the raw voltage route.
This PDF shows the factory locations where that voltage is taken from
45xp raw voltage terminals
1 Like
It looks like your question was answered, I just wanted to also put a quick reminder here that Hypertherm CPC ports will only function if you use a machine torch. If you use a hand torch, the CPC port will lock out.
Also, the voltage divider of this CPC port will have a selectable ratio. Be sure to set the voltage divider to 50:1 when using the LS-THC
Thank you for all your help. I really appreciate it.
1 Like