How to cut a single line

[TinWhisperer]

@thebigorangescout

I had the pierce clearance at .055.

for the line cutting part this need to be set to zero.

@thebigorangescout

Here is the dfx file,

Without a F3D file i can not see how you have done your set up.

I took the DXF file and ran it though F360.

Here is a F3D with a parameters set up how I may go about it. I assume 14 gauge mild steel as the material.
here is and torch setting I used

udot shed 4484 v1.f3d (603.1 KB)

udot shed plow 4484.nc (114.6 KB)

Cut file

@thebigorangescout

Pierce delay is set at .5 sec

Good, now when your about to run this program dial back your pierce delay in firecontrol to 74%

Let me know how this pans out.