GibbsCam post processor

Has anyone found a GibbsCam post that works reasonably well for the MR1?

A standard Fanuc PP would get you started. Just remember no canned cycles. I’m sure you may run into a few other things that would need tweaked or cut out, but it would cover the basics.

Thank you I appreciate that

Wait no canned cycles? Does this include g81? How does Mr1 drill holes out of curiosity?

The MR1 drills in a G1 feed down, G0 rapid up.
I’m not very familiar with Gibbs, but it should have an option to use canned cycles or not when creating a drilling operation which will post out the code as feeds and rapids rather than G8x cycles.

1 Like

The lack of canned cycles did prevent me from writing a post for CamBam. Hopefully Gibb’s offers the option that you need.

1 Like