so this is from your other post…
so this is from your other post
toolboy - Thanks for the reply, FYI - I just made a new topic so not to duclipcate the information feel free to respond to that one. But the answers to your questions are - I am using a Miller 625 X-treme yes on the pro table with no THC. The air is 125 psi, dried and runs through a new miller air filter. The cut was made with a 40 amp tip and was set at 35 amps on the machine. The speed was 50 IPM and was processed on Fusion 360. The height was visually about 0.15 to 0.25 above the material, I could clearly see the length of the arc when the cut was being made.
seriously your torch is too high…do what @ds690 says…measure it…