Everlast Power Plasma 82i (two month review)

Plasma Cutters
82

You and I think alike😬

83

@Bigdaddy2166 John do you have a favorite post on how to wire the Everlast to raw voltage?

1 Like
84

I would go inside and connect like 99% of us did.
There have been reports that the cnc port pins work. I opted to go old school and have never looked back. 5 yrs now without any issues at all.
Thats my two cents pal.

2 Likes
85

But is there a post on here with pics that you have hidden away of that process?
If not I will do some searching

86

Lots of posts with pics. Run your search

1 Like
87

Here it is

3 Likes
88

Mine showed up this morning. Not sure I will have time to set it up for a bit. I have to do our septic system this weekend… before the deep freeze.

1 Like
89

I am tinking I might try and sell mine, I really dont have a need for it. and I sure dont have time to switch it over for awhile. I will give it a week or two to sink in. Let me know if you got a warranty card.

I was going to call them today as I did not get one, but ran out of time.

I wish this had come along when I bought the table!

2 Likes
90

I did not get a warranty card. If you do let it go, let me know. I have a friend that wanted one after I told him about the deal. Problem was, I told you guys first and they were gone.

2 Likes
91

Yeah, I probably would list it locally first due to the size of it, and I don’t have the box that it came in. I do have the foam inserts that held it, but getting the box and packaging it would be a pain in the butt.
Whereabouts is your friend?

1 Like
92

Understood, located in Nebraska.