Ammocan
January 23, 2025, 5:56am
10
I’m Really hoping someone who has experienced this can solve my issue.
I just finished cutting two separate programs that were 50 minutes each (big tree silhouette) both were completed without errors of any kind. the next program I start cutting out some simple square tabs and they are all messed up. I noticed the torch head is driving into the material and dragging real bad. I had to go back and re set all the bearings, cleaned everything and the whole assembly is back to normal but the issue …
here is my experience. even if your problem is not the same cause they look similar and there was a lot of great trouble shooting advice in this thread to try out.