Crossfire (looking for demonstration near Montgomery)

[hawk]

Does any one have a 4x8 in Alabama with in 60 miles of Birmingham or Montgomery that I could come to see before before I buy one to see it run. HAWK

[ChelanJim]

I am going to move this to the XR category: that is the 4X8 table. I have the smaller table and on the Wet coast of Washington state. Yep…it’s raining.

But, welcome to the forum and good luck with your journey…wherever it may take you!
I know this is not like watching it but this is what a member of this forum did today:

Beveling Xr 4x8

You have to edge start on 3/4 steel, cannot plunge cut the consumables will not last long. I cut these plates this morning out of 1/2 steel on my XR with power max 45 Hypertherm . No bevel but I spent about 3 hours resetting z axis bearings and squaring torch when I first assembled XR table couple years back no problems since. [20231109_081004] [20231109_081407] [20231109_081548] [20231109_081930] [20231109_081939] [20231109_090741] [20231109_090748]