@ChelanJim, just re-read this post. Great info, thanks! Saw another thread you posted to a little over a year ago: Pro feeds and amperage
Is there “feed optimization” for the Crossfire? If so, is it in Fusion or FireControl?
Also. Razorweld sent me their cut sheet for the RazorCut45. For mild steel their speed is over 300 ipm for anything thinner than 16 ga. I just read that the Crossfire has a max speed of 300 imp.
Does that mean that when I’ve been cutting 18 ga at the RW recommended 45A//365 ipm, it hasn’t been going that fast? (Assuming there’s a place on FireControl where I can see live speed, which I intend to look at next time.)
Also, their pierce delays are super short, 0.0 for anything under 16 ga. In the thread I just referenced, @Simsworx stated a .5 sec pierce delay for 18 ga. Should I be bumping it up from the .001 sec I have it set at in my Fusion tool library?
And for a totally unrelated quesion, why do my pieces always stay attached? Assuming this has something to do with my lead in and (lack of) lead out? (or maybe pierce delay time, too?)
Sorry for all the questions.