Anyone wire up a cutmaster 42 plasma cutter

[TinWhisperer]

Welcome to the forum

THC - TD Cutmaster 42

Just wanted to follow up since I had a few minutes to run some tests today. For reference the sheet from the last job that I ran using smart voltage was still on the table so I had no setup that had to be done for these tests. I created a 8" by 2" rectangle to use for the test and posted to the machine with the same settings as before (16ga steel, 35amps, 125 IPM, .175 pierce, .125 cut height) I ran three cuts with THC off and the leads plugged into a multimeter to check voltage. All three r…

This forum does have the ability to search by keyword

Don’t mind @toolboy, he hates Saturdays.