Adding stop to code

[James5]

M6 - not sure on Pro. I’ve seen M0 - program pause being used by some other folks on Pro.

Check out this post for some info on adding code to sheetcam.

THC Issue or Machine Setting issue?

Check out the 2 commands on the left in the operations window (the “G” and the arrow thingy) [sc-gcode] To do a pause like what you are talking about if you have operations separated by layers, put a G-Code M0 command between each operation. To do a move - use the “move to a given coordinate” as needed. When you post process, these steps will be :built in" to your job. Hope that helps!