3/8 Steel Cuts With RZ Cut45

[ChelanJim]

This post is probably what @72Pony is referencing. Just finding out the cut height is part of it. Reacting to how IHS is interpreting your situation/setup is the other part.

Machine torch raises

I have the same table (pro) and the Hypertherm 45XP with the machine torch as well. Recently, I had to go thru a wholesale recalibration of my torch height. I thought the THC or IHS was malfunctioning as I noticed that the torch seemed higher than usual. Also, I was having a terrible bevel with the cut with dross on both sides of the plate. Initially, I just arbitrarily reduced my cut height from 0.060 to “0.040” in CAM. I didn’t measure. It was still doing bad cuts and too high. I ran this fil…