Water table problems

[TinWhisperer]

@justgregg

i made the mistake of doing a test cut without water. The torch stopped right above the seam and kept burning. it melted all the sealer in a 4’inch area. The area was warped and the seam had opened up. I tig welded just that area, but got carried away in one area. I used a stronger adhesive and the other area that didnt get nuked held water. Im thinking as a last ditch effort is to run a bead of the sealer underneath the seam in the damaged area to see if it will seal.

@justgregg Is this the same water table you have been having issues with?