I had an idea for a storage tank… any thoughts or comments would be great. I was just going to fab a stainless 10 gallon tank with a fitting on the top, and about an inch up on the side. The fitting on the top would have a hose going to the drain in the water table. The fitting on the side would have a ball valve and a hose that you could place in the water table so when you apply air pressure (not too much) to the tank, it would transfer the water back to the water table. I was also going to either make the top of the tank bolt on, or put a small clean out door in the bottom. Am I crazy, or would this be an easy way to transfer water without all the extra time and money on a pump? I’m open to any constructive criticism… so let’s have it lol
1 Like