Vibration on the gantry during breakin program

CrossFire ® Troubleshooting
1

While running the breakin program, I notice a bit of vibration as the coordinates near zero. I have attached a short video capturing the vibration.

Actually, I don’t know how to get a video from my android to this message.

2

Hi @doleslie some vibration on the machine is normal especially without material loaded. We wont be able to tell if it is excessive without a video, however. Can you upload a quick video to YouTube and share the link here?

Thanks!
Mike

3

Hi Mike:
Thank you for your response. I did have a 2x4 sheet of CRS (22 gage) on the slats held down by magnets.
The vibration occurs in one general location. It is pronounced in the direction, but it occurs in both directions.

See youtube video: https://youtu.be/5MbGHgmeMwc

It’s subtle, but it occurs when the torch is near the orign. I may need to submit another video if necessary.