I slipped and felll today on a wet spot on the floor in my shop and guess what… I caught myself on the wire harness to the torch broke the connection pins inside the torch head …
Got on phone with RazorWeld/ Sean new torch shipping out in am. Expensive fall…
See photo.
That really Sux. Was you changing tips?
No, walking around the table, slipped in water that splashed out on the floor
I have been going to get a rubber mat for that reason. my floor is very slick when water gets on it. I been lucky i guess.
@jimt if you get one get one that is one piece. I actually slipped on a 3’ section of mat I had laying on the floor where the water always seems to be so I didn’t have to walk/stand in it… Bit me in the a**! The mat slid on the water…
Ok. And I hope you didnt hurt yourself.
Replace the pins and you will have an extra torch.
sent you a pm (min 20 character)
I probably will when I figure out how to get my hands on some pins…
i got some pins now
drop a pm
2 Likes
Where did you get the pins? I’m in need of two of them. Also can’t quite see how I’d change them out, but it’s the only thing holding me up. Thanks
hi, could you tell us where you got pins?
Welcome to the forum.
Send me a email or call me on Monday.