Test fire wont start up

[langmuir-aksel]

We have a troubleshooting guide for this issue here on the forum:

Torch Not Firing - Troubleshooting Guide (MACH3 LEGACY)

Torch Not Firing – Troubleshooting Guide 1.) Confirm that Mach3 Settings are correct: a.) At the top bar click Config > Ports and Pins and then click the tab for Output Signals. Your screen should look identical to the screenshot below with Output #1 checked green and Port# = 3 and Pin Number = 4. No other outputs should be enabled. If your configuration is different, make the correct changes and click apply and then OK. [image] b.) Go back into Config > Ports and Pins and select the tab ‘S…