Rounded corner issues with Fusion 360/ Plasma

[zox]

I’m using a CrossFire with Fusion 360 to generate gcode for Mach 3.

I am importing DXF files from RHINO into Fusion, creating gcode and running Mach 3. I’ve been able to dial in a clean cut, however my corners keep getting rounded.

Anyone have any suggestions what’s going on??

BTW- I’m new to all of this so forgive my ignorance if this is a simple setting:)

[TinWhisperer]

In the manufacturing workspace.

Click the fabrication tab

Selection 2d cutting

2d profile menu will pop up

In the 4th tab select select compensation type, computer in control.

This open another box below this option “outer corner mode”

Select “keep corners sharp”

Then proceed as normal from here.

hope this is the fix you are looking for.