Hey guys I’m new to the Forum. Recently got my crossfire up and running I picked it up a while ago along with the plasma cutter probably about 10 months ago. So the plasma cutter is brand new went to run my first test cuts, see the Torches firing between cuts so I do a quick search and find that I probably have it in 4T mode which indeed I did but when trying to switch it into 2T mode it will not it stays in 4T .I have ran out of ideas on what it could be so I figured I’d give it a shot to see if anyone else has ran into this problem. If anybody have any info on what it could be it would be appreciated.
did you ever figure this out?
Yes it was the control board. Contacted customer service they warranty it with no problem. between first Contact and getting the new control board was within two weeks. Its the control board behind the 2t/4t button it is about the size of a credit card.
1 Like