So I called primeweld today on my break. They told me to ohm the plasma cutter when it is running to see if it closes when it is done cutting. My Buddy has a good meter so I asked him to bring it over. And it was jumping around when it was just at idle with it turned on. So tomorrow I am going to hook up my old plasma cutter. And see if it still does it. If it doesn’t then I am calling prime weld and telling them about it and hopefully they warranty it which they should I have only cut with it about 6 times now. And I also made a quick new design. To see if it was just the ball and it did it with that one too. Oh and as it was cutting he said the opening but the cutter would shut off in between Cuts but it must still be cutting a little after it starts moving.