I am cutting some stainless plates and I am not getting cut penetration at the end of the cut. The rest of the cut looks great. I am bewildered.
Following book specs for 65amp sync cartridge
Designed in fusion360 and sheetcam.
Are we looking at the bottom of the cut here?
Is your cut direction correct?
This is the bottom of the cut. I believe I am running reverse cut direction.
Is there a chance that you are losing air volume/pressure?
my air valve was cracked open and i was loosing pressure. I recently moved shops and did away with my buffer tank. now I know! thanks yall!
2 Likes