So my Macbook is the M1 silicon chip running Ventura 13.0. The wall plug in that it uses does not have a ground prong in it. The Mac only has USB-C connections so when i connect it to the tables USB I have to use a USB to USB-C adapter. Could that be where the problems coming from? If you need a better picture please let me know and I’ll get you what you need. The computer connects to it fine and I can send it commands, its just when I start to cut something complex and the plasma turns on that it doesn’t complete the tool path.
As far as the rest of my wires I have my divided voltage wire and the torch on/off wire coming down from the plasma there on top of the shelf and down to the box. and the rest I’ve attempted to tuck up underneath next to the control box. I took the panel off so the setup would be a little easier to discern. The plasma, table, and the compressor are all on their own individual dedicated circuits. Thank you all I really appreacite your input and help on these issues!