Since I setup my table, I’ve been using 0.060 for everything. I did some early measurements when I was test cutting and they seemed to be close to .060. Now I’ve been using the table a while I need to rethink all my settings - my early runs were very rough. I’m going to start experimenting with .035 at lower amperage and go from there. After seeing some posts from @CHUCK I obviously need to keep at it - he has some amazing looking cuts.
Of course, I’ll have to wait until I get my machine back…It’s in the ICU getting a liver and brain transplant and fighting off some 'vid-19. Miller 625 Xtreme Loss of Pilot Arc