Machine not completing all cuts

I am using Sheetcam and Mach3. I downloaded the “FBOMB” bottle opener from fireshare, created the G code in sheetcam and loaded into mach3. The machine will not complete any of the cuts. The opener opening not complete, the outer body of the bomb, not complete, the cutouts in the fins, not complete. All the paths look good in sheetcam and are present on the mach3 screen. Any ideas? I’m wasting steel trying to figure it out. Thanks.
Barry, Oakland, KY.

If this is really true, then you may have your Plasma Cutter in 4T mode. It needs to be 2T mode.
However, when you say the paths ‘look good’ in sheetcam, upload a screen shot of the job with cutpaths shown.

Please post your program. You likely need to increase your pierce delay.